DIKA PRO SYSTEM  6,Rue Claude Chappe ZI 10150 Pont Sainte Marie TROYES (aube) FRANCE

Tel:0033(0)3 25.45.03.03 plotter@dikaprosystem.com

 

Introduction of Laser Engraving

 
The use of laser engraving and cutting, the process is very simple, as in the use of computers and printers print on paper. You can use a variety of circumstances Win98/Win2000/WinXP graphics processing software, such as CorelDraw, such as design, scan the graphics, vector illustrations and a variety of CAD files can be easily "print" to the carving machine. The only difference is that the Tu toner will print on paper, and laser engraving is the laser strikes into wood products, Trans Am tablets, plastic sheeting, sheet metal, stone, etc. Almost all the material on.

     * Lattice sculpture

     Lattice sculpture resembles high-resolution dot matrix print. Laser head swinging around, each one carving out a series of points of a line, and then moved up and down at the same time the first laser carving out a number of lines and finally a full-page images or text. Scan graphics, text and vector can be used by Lattice sculpture.

     * Vector Cutting

     Lattice carving and different vector by cutting in line for the outer contour. We usually use this model in wood, Trans Am tablets, paper and other material on the cutting penetration, but also in a variety of materials surface marking operation.

     * Carving speed:

     Carving speed refers to the first mobile laser speed, usually IPS (inches / sec), to bring high-speed production efficiency. Cutting speed is also used to control the depth of specific laser intensity, the slower the speed, cutting or carving on the depth greater. You can use the engraving machine panel regulating speed, the computer can also use the printer driver to adjust. 1% to 100% within the scope of adjustment is 1%. Hummer of advanced motion control system will allow you to the high-speed carving, still have the carving hyperfine quality.

     * Sculpture Strength:

     Carving strength in the material that strikes into the surface of the laser intensity. For specific sculpture speed, intensity, the greater the depth of cutting or carving the greater. You can use the engraving machine panel conditioning intensity, can also use the computer printer driver to adjust. 1% to 100% within the scope of adjustment is 1%. Greater intensity, the greater the equivalent speed. Cutting depth of the deep.

     * Spot Size:

     Laser beam spot size can make use of different focal length lens to regulate. Small spot of high-resolution lens for carving. Big spot for the low-resolution lens sculpture, but Vector cutting, it is the best option. New equipment configuration is the standard 2.0-inch lens. Spot in the middle of its size, apply to all kinds of occasions.

     * Carving material:

     Wooden products, plexiglass, sheet metal, glass, stone, crystal, Corian, paper, two-color boards, aluminum,